Instructions / Assembly

Aspen™/Econoline™/Colonial
™
/Savoy™ - I3015 - 0308
INSTALLING THE DOORS
STEP 1 Removing the Old Doors
Remove old doors, brackets, top channel and
bottom track.
STEP 2 Installing the Top Channel
A. Measure the opening at the top of the closet from
wall to wall.
B. Cut the new Top Channel (#2) to this dimension.
When cutting the Top Channel (#2) we recommend
that you use a Miter Box and Hacksaw for a
straight cut. Cut one side only.
NOTE: If your closet has bumper jambs you may need to
notch your Top Channel (#2) on each end.
C. When cut to proper length, install Top Channel
(#2) up to the top front of closet opening making
sure that the front of the Top Channel (#2) is flush
with outside walls (See Figure 1). Hold up the Top
Channel (#2) in the desired position and with
your Pencil, mark where the pre-drilled holes are
in the Top Channel (#2).
D. Remove the Top Channel (#2) and drill holes
using 1/8″ Drill Bit where you made the pencil
marks. Now install the Top Channel (#2) in place
using the six #8 x 1-1/2″ PH SMS Screws (#5).
STEP 3 Installing the Bottom Track
A. Make sure that you have used the FLOOR
CHECK LIST to determine which floor and
installation you will use.
NOTE: If the floor board molding continues into the
c l o s e t opening, you may need to remove it so that
the Wardrobe Doors will close flush to the wall.
B. Locate Wood Strip (#4) supplied in kit and
measure inside bottom closet opening and cut to
length.
C. Find the correct offset measurement using the
O ffset Measuring Ta b l e on Page 3 (B
Measurement) for your particular installation. From
the front edge of closet opening inward, measure
using dimension from table and make a pencil
mark on wall. Do this on both walls, i.e., right and
left walls (See Figure 2).
D. Place front of Wood Strip (#4) up to pencil mark
on wall (See Figure 3). Do this on both sides.
Now attach Wood Strip (#4) according to your
O ffset Measuring Ta b l e .
E. Cut the Bottom Track (#3) to your measurement
of the inside closet opening. Slide the Bottom
Track (#3) over Wood Strip (#4) and attach with
#8 x 1/2″ Truss Screws (#6).
PENCIL MARK
TO LOCATE
FRONT EDGE
OF WOOD
STRIP
PENCILMARK
TO LOCATE
FRONT EDGE
OF WOOD
STRIP
4
Figure 1
Figure 3
Figure 2
ALIGN TOP
CHANNEL FLUSH
WITH THE WALL
Aspen/Econo/Colonial/Savoy 3/14/08 3:56 PM Page 4