Manualshelf

Instructions / Assembly

ManualsBrandsUnbranded ManualsBuilding materialsSurPro 15 in. to 23 in. Adjustable Height Dual Legs Support Magnesium Drywall Stilts
1234
NOTE:
If you cannot adjust the leg band to a height that is comfortable,
call to order an extra long side pole for extra height adjustment.
LUBRICATION
ADJUSTMENT
Keep all pivot points and adjustment joints clean and
lubricated. Lubricate lightly when necessary with a
silicone or graphite based lubricants. Use water only for
clean-up of stilts. Keep soles clean and free of lubricants
or any debris which could cause slippage.
Contact your dealer or customer service for parts.
®
Always use genuine SUR-STILT parts to repair or
replace worn or damaged parts.
MAINTENANCE
GENERAL REPAIR AND
REPLACEMENT PARTS
To access nylon sleeves, disassemble the upper foot
plate. Remove the small sleeves from the extension
tubes. The large sleeves can now be removed and
replaced.
REPLACEMENT OF NYLON SLEEVES
6
3
SIDE POLES AND LEG BANDS
1. Position side pole assembly facing forward with each side pole straddling
the stilt. Slide the side pole holders (H171) into position between each metal
side pole bracket (H131). Then carefully slide the assembly downward into
the side pole attachment bracket on the stilt body.
2. Fasten and tighten side pole holders with included screw and nut. (H132)
3. Fasten and tighten side poles to stilt body with included screw and nut. (H124)
ADJUSTMENT
1. Position the side pole holder in the side pole bracket slots according to your
calf size, so the stilts will stand straight when mounted with both side poles
equal distance from the center of the stilt. Tighten well using the 1/4" x 1 3/4"
# 20 cap screw with locknut.
2. Remove the leg band locking screws and adjust so the top of the leg band is
one to two inches below your knee. Insert leg band locking screws, locking
each leg band in place.
3. Adjust the laces so your calf fits comfortably in the leg band. Double knot to
insure a secure fit.
HEEL BRACKETS
1. Adjust the heel brackets using the #10 - 1/2" Phillips machine screws and
locknuts. Adjust the heel brackets so your outside ankle bone is directly
over the rear pivot bolt and tighten well.
HEIGHT
1. Remove the wing bolts.
2. Evenly raise the stilt legs to the necessary height.
3. Install the wing bolts and tighten fully engaging the nut.