Installation Guide

7
8. Unit Assembly
Door Handle Installation
Backwall is attached to the stile of the
front frame
Shampoo dispenser installation
a.Connect the front frame with two side-back
walls. The ½” stainless steel screws must
be put on from the backside of the shower.
Therefore, this connection must be done off
the shower base. Have doors removed from
the front frame.
b.Connect two back wall together with 90
degree angled frame to cover over the square
frame. Use ½” screws.
c.Connect water supply to the shower. You
may need to move the front-frame-backwall
assembly onto the base but leave enough
room for water connections.
d.Connect and secure all water lines to the
shower/bath enclosure. Make sure all
connections are water-tight
e.Move the front-frame-backwall assembly
onto the base pan and in place.
f.Drill two pilot holes (1/16”) at top, middle
and bottom on both stiles. Use cup washers
and 1” long #6 screws (smallest head size) to
attached the front frame to 1X4”s. Place
decorative covers on to the cup washers.
g.Place the roof of the unit on top of the
shower enclosure, aligning it with the walls,
and fixing it to the wall studs through the
edge foldup.