Installation Guide

1. Pre-installation

Check the area you want to install your unit for the following:

a.Water hook-ups are located on the left back wall (when facing the shower) at 24” from the

corner and 48” above the floor. Please use flexible PEX or flexible water hoses of about 3’ long

and with ½” FIP fittings for both hot and cold water. If right hand side water supplies chosen,

please have water supplies on the right hand at 12” from the corner and 48” above the floor.

b.The drain center is 7-1/2” from each wall for S-3232/S-3232EF, and 10” for S-3636/S-

3636EF. For S-3232 and S-3636 models, floor drain pipe must be plumbed to the location right

below the base drain, and use US standard 2” drain piece (not included). For S-3232EF and S-

3636EF models, Easy Fit Drain (included) can lead 1-1/4” flexible PVC hose to existing drain

location.

c.Install 1X4 vertically on both walls: For S-3232 and S-3232EF, 30-1/2” from the corner to

the outer edge of the 1X4 and 7” above the floor. For S-3636 and S-3636EF, 34-1/2”

from the corner to the outer edge of the 1X4 and 7” above the floor.

2. Base Preparation

a.Remove the shower base pan from its

packaging.

b.Remove all protective covering films

from the base.

c.Adjust the feet of the base so that the

base is level when lying flat on the

ground.

d.To install EF drain or standard 2” drain,

take out the drain flange.

e.Apply silicone sealant to the bottom side

of the rim on the drain flange and place

it over the drain hole of the base pan.

f.Put on the rubber gasket from the bottom

side of the pan to the flange. Screw the

drain body elbow to the flange until

tight. Do not over tighten as this may

crack the plastic.

g.Attach 1-1/4” PVC flexible pipe to the

drain body elbow.

h.Extend the flexible PVC pipe and feed it

into the floor drain. You may use 1-

1/4” coupling to secure the drain pipe to

your floor drain.

i. Once the PVC flexible drain pipe routing

is decided, spray polyurethane foam to

the bottom of the base pan.

j. Secure the pan to place with silicon

sealant against the walls and floor.