Use and Care Manual

Re-Lighting Your Side-Kick

Should your burner flame be accidently extinguished.

 Immediately make sure the control knob is in the OFF position.

 Open hood (If not already open).

 Wait 5 minutes for accumulated gas to clear.

 Push control knob down and rotate counterclockwise to HIGH.

 Using a grill lighter or match, light the burner through the lighting hole

located on the bottom of the grill.

 Once burner is lit, adjust control valve to desired cooking temperature.

WARNING:

Always open hood before turning on gas and lighting burner,

failure to open the hood before lighting could cause an explosion

causing property damage, injury, or even death.

Removing Burner and Venturi Tube

1. Turn Side-Kick bottom side up.

2. Remove screw “B”(see diagram below) Do Not Lose Washer.

3. Turn nut “A” (see diagram below) counter clock wise until burner

and tube are free.

4. To install new burner and tube, reverse steps #2 and #3.

• Important - Venturi tube must fully engage valve orifice for

nut A to fully engage threads on venturi tube.

• Nut A must be turned to full length of threads.