Installation Guide

ManualsBrandsUnbranded ManualsDecorative PanelingDingewood 1 in. x 4 in. x 92 in. Rustic Barn Alder Trim Panel (9-Piece Per Box)

For Additional Information – http://www.dingewood.com/

For Assistance Email: Sales.DingeWood@gmail.com

APPLICATION INSTRUCTIONS FOR DINGEWOOD SIDING

SQUARE FOOTAGE

First, determine the amount of lumber you will need. You will need to determine the square footage of

your space by multiplying the length x width of your project, making sure to subtract for windows and

doors. Next determine how much siding to purchase. Use the charts below to determine coverage on

your Dingewood purchase.

TONGUE AND GROOVE SIDING NOMINAL SIZES (CHART 1)

Thickness (in.)

Nominal Width (in.)

Finished Width (in.)

11/16

4, 6

3-3/8 | 5-3/8

TONGUE AND GROOVE SIDING COVERAGE TABLE (CHART 2)

Nominal Width

(inches)

Dressed Width

(inches)

Exposed Face Width

(inches)

Lineal Feet

Factor

Board Feet

Factor

3-3/8

4.0

1.33

5-3/8

2.4

1.2

PREPARATION

Remove the trim around windows and doors. Use a stud finder to locate wall studs and ceiling joists.

Tongue & Groove Siding can be installed horizontally or vertically, so determine which direction you

would like the wood to go.

NAILS

Nails should be stainless steel, high tensile strength aluminum, or galvanized. Nails should be rust proof.

They should be small enough to enter the tongue without splitting the wood and small enough to not

Summary of content (4 pages)

PAGE 1
APPLICATION INSTRUCTIONS FOR DINGEWOOD SIDING SQUARE FOOTAGE First, determine the amount of lumber you will need. You will need to determine the square footage of your space by multiplying the length x width of your project, making sure to subtract for windows and doors. Next determine how much siding to purchase. Use the charts below to determine coverage on your Dingewood purchase. TONGUE AND GROOVE SIDING NOMINAL SIZES (CHART 1) Thickness (in.) Nominal Width (in.) Finished Width (in.
PAGE 2
need predrilling. They should not be visible once inserted into the wood. Points should be diamond or blunt. HORIZONTAL APPLICATION In horizontal application, start at the bottom and work up, with the groove edges facing downwards. Leave a gap .5” at each wall to allow for expansion and contraction. Siding up to 6 inches wide can be blind nailed with one siding nail per bearing toe-nailed through the base of each tongue.
PAGE 3
In vertical application, start at one corner with grooved edge toward the adjacent wall. Leave a gap .5” at each wall to allow for expansion and contraction. Use a level or plumb line to ensure that the first board is installed plumb. Siding is nailed to horizontal blocking lines installed between studs or to furring strips. (See Chart 3) As with horizontal installation, pieces up to 6 inches can be blind nailed and wider pieces should be face nailed.
PAGE 4
FINISHES If you would like to protect your wood surface, installed wood may be top-coated with Weather Wash brand topcoats. These finishes can successfully hold the weathered look. Use White Maintenance Oil to add the look of patina. Use Clear Maintenance Oil to bring back more of the warm browns in the wood. Use Varnish topcoats for a high degree of wood protection and select the sheen you desire. Dingewood siding is compatible with paint, for a customized weathered look. www.WeatherWashCoatings.