Use and Care Manual
First Choice When Quality Matters
NORTH
AMERICA
Plunger Pumps
Operating Instructions and Parts Manual RSV Series Pumps
General Safety Information
(continued)
Maximum water temperature is
140°F.
All positive displacement plunger
pumps must have a safety relief valve
installed on the discharge side of the
pump, this valve could be either an
unloader or regulator and must be of
adequate fl ow and pressure for the
pump.
Adequate protective guards must
cover all moving parts. Perform
routine maintenance on the pump and
components.
Use only components that are rated
for the fl ow and pressure of the pump,
this would include hose, fi ttings, safety
valves, spray guns etc.
Electric Drive Pumps
Your power supply must conform to the
system requirements.
The motor must be grounded. Use
GFCI plugs and receivers.
Do not handle the pump/motor with
wet hands.
Only use power cords that are in
good condition.
Never pull the unit by the power
cord.
Never spray or clean the unit with water
Failure to follow these warnings
may result in personal injury or
damage to property.
Installation
Direct Drive Gasoline Pumps
1. Install the
shaft key into the
keyway and apply
a light coating of
anti-seize on the
engine shaft. (See
Figure 3)
2. Align the two key ways
and push the pump completely
onto the engine.
3. Install all four (4) bolts and tighten
evenly.
4. Remove the red
shipping oil cap and
install the black
crankcase vent cap.
(See Figure 4)
5. Install the appropriate
unloader valve and other
accessories.
6. Install the appropriate water inlet
and discharge fi ttings.
7. Connect the water supply hose and
high-pressure discharge hose/spray
gun.
8. Turn on the water supply.
9. Open the spray gun to purge the
system of any air.
10. Start the engine.
11. Adjust the engine speed and
unloader valve.
Winter or Long Time Storage
1. Drain all of the water out of the
pump.
2. Run a 50% solution of a RV or
non-toxic/biodegradable antifreeze
Figure 4
Figure 3
Plunger Pumps
Operating Instructions and Parts Manual RSV Series Pumps
First Choice When Quality Matters
NORTH
AMERICA
Pos. Code Description Qty. Pos. Code Description Qty.
1 1980300 Nut M6 1
2 2760420 Grub screw
M6x12 1
3 1980540 Unloader knob 1
4 1980220 Spring plate 2
5 2760410 Spring 1
6 2760400 Valve piston 1
7 2260100 O-Ring
Ø6.02x2.62 1
8 660190 O-Ring Ø6.07x1.78 1
9 2760210 Ring 1
10 2760050 Piston guide 1
11 1200690 O-Ring Ø15.6x1.78 4
12 394280 O-Ring Ø12.42x1.78 2
13 2260070 By-pass jet 1
14 2760090 Seat 1
15 770140 O-Ring
Ø11.11x1.78 1
16 1982520 Hose nipple 1
17 480480 O-Ring Ø4.48x1.78 2
18 1250280 Ball 1
19 1560520 Spring 1
20 2760230 Detergent injector
3/8” G 1
21 2760270 O-Ring Ø12x1 1
22 1470210 O-Ring Ø9x1 1
23 2760120 Injector insert 1
24 2760200 Spring 1
25 2760130 Jet 1
26 1460430 O-Ring
Ø4x2.5 1
27 801080 Bolt M6x50 (92 in/lbs) 8
28 1381550 Lockwasher 8
29 2760020 Head 1
30 2760140 Ez-start plug 1
31 1982240 Ball 1
32 1981800 Spring 1
33 2760260 Plug
1/4” G 2
34 2760180 Plug
(442 in/lbs) 3
35 2769050 Complete valve 6
36 2760220 Support ring 3
37 1342761 Gasket 3
38 1981580 Ring 1
39 1981570 Piston guide 3
40 770260 O-Ring
Ø23.52x1.78 3
41 1260440 Gasket 3
42 640070 O-Ring Ø13.95x2.62 3
43 2760310 Spacer 3
44 1260460 Oil seal 3
45 2760010 Pump body 1
46 1266740 Bearing cap 1
47 1260790 Circlip
Øi52 1
48 1780550 Snap ring 1
2760340 Bearing ⌧ 1
49
1780490 Bearing 1
50 880130 Oil cap 1
51 2760040 Piston 3
52 1780050 Piston pin 3
1780040 Con rod
Aluminum ⌧ 3
53
1780710 Con rod Bronze 3
54 2760280 O-Ring
Ø101.27x2.62 1
55 802190 Bolt M6x12 (71 in/lbs) 4
56 2760110 Rear cover 1
2760350 Bearing ⌧ 1
58
1321190 Bearing 1
59 1321080 Snap ring 1
62 2769201 Complete pump head 1
64 480671 Oil seal 1
66 180030 Bolt
M8x20 4
67 820440 Set screw M6 1
1780340 Hollow shaft Ø1” 1
1780920 Hollow shaft
Ø1” 1
68
1780330 Hollow shaft Ø1” 1
1780590 Hollow shaft Ø3/4” 1
69
1780600 Hollow shaft Ø3/4” ⌧ 1
70 1780580 Flange F25 ⌧ 1
71 2760290 Flange
F40 1
AR64516 Oil 1
OIL CAPACITY - 12 OZ
Legend
Ø 15 Ø 15 Ø 15 Ø 15
For For ⌧ For For
RSV2.5G25 RSV3G25 RSV3.5G35 RSV4G30
For For
RSV3G30 RSV4G35
RSV4G40
For
RSV3G35








