Installation Guide

69
This equipment should be installed,
adjusted, and serviced by qualified electrical
maintenance personnel familiar with the
construction and operation of solar/electrical
equipment and the hazards involved. Failure
to observe this precaution may result in
bodily injury and/or damage to property.
Step 1: Select the right input voltage
Input voltage can be 12V/24V/48V
depending on which products are used. It is
recommended that the inverter be powered
by a battery or battery bank, as the current
drawn from the inverter can become
extremely high.
Step 2: Connecting inverter to battery
Set the switch to OFF position (inverter and
appliances). Connect the battery cables to
their respective colors on the inverter i.e.
black cable goes to the black terminal on
the inverter, and the red cable goes to the
red terminal on the inverter.
A power inverter, or inverter, is an electrical device that changes direct current (DC) to
alternating current (AC); the converted AC can be at any required voltage and frequency with
the use of appropriate transformers, switching, and control circuits.
10.1 General information about power inverters
10.2 Wiring instructions
Figure 10.1
Simple diagram on how the inverter works
Inverter Wiring
DC In AC Out
WARNING
Please read these instructions carefully before attempting to carry out any
installation and wiring. Contact Technical support for any questions
concerning the installation.
Appliances are
connected to the AC
Side of the inverter
Fuse
Single 12V
battery or
multiple batteries
in parallel
charging from
solar array,wind
turbine and/or
AC-DC charge
AC OUTPUT AC OUTPUT
L N G
ON
OFF
REM.
REMOTE
ECO
GF
COMM.
50Hz
60Hz Nor.