Installation Guide

Fasten the bottom of the T-Slotted Brackets to Support Arm

A. Slide T-Bolt (F) through same slot as previous step. The distance that the bolt should slide

depends on the angle that the T-Slotted Bracket (A) was fastened to the top L-Channel (B).

Usually anywhere from 150mm to 250mm (6in to 9.8in) although it can exceed that if necessary.

B. The back planes of both L-Channels (B) should be parallel and flush to the pole. Achieving

this may require reorienting the T-Slotted Bracket (A). It is recommended to fasten the Support

Arms (D) to the T-Slotted Brackets temporarily until you can attempt to orient the assembly on

the desired pole.

C. Once the assembly has been temporarily fastened, and is now near the pole, attempts can

be made to attach the Pole Mount to the Pole.

D. If the backs of the L-Channels (B) are not flush to the pole surface, adjust the Support Arm

(D) angle as needed until the desired angle is achieved.

E. Once desired angle has been achieved fasten the Support Arm (D) to T-Slotted Bracket (A)

with a small Nut (K).

Figure 5