User Manual

Wiring diagram of a RGB strip:
Note: Minimum radii are only permitted in sections with no components.
If you need to connect more power, it is necessary to increase the wire sections proportionally to
the supply current.
Before switching on, make sure that the input power supply voltage corresponds to its operating
range.
When working with the strip, observe the rules of protection against static electricity. Static
electricity may damage LEDs, which will lead to reducing their lifespan and to subsequent failure.
Table 1. Recommended cross-sections of the copper power wires at a voltage of 12 V.
Wire length 5 meters
Power, Watt
Current, А
Wire section, mm 2
Wire diameter, mm
12
1
0,13
0.4
24
2
0.25
0.56
48
4
0.5
0.8
72
6
0.75
0.98
108
9
1.12
1.2