Instructions / Assembly

SLOPE
END LAP TAPE
HIGH SIDE ATTACHMENT
(3 FASTENERS PER PANEL)
(6 FASTENERS PER PANEL
FOR HIGH WIND LOADS)
END LAP ATTACHMENT
(SEE DETAIL “B”)
SIDE LAP ATTACHMENT
(SEE DETAIL “A”)
ROOF PANEL
14 x 2 - 410 STAINLESS
STEEL SELF DRILLIER
6 EACH PER PANEL
INTERMEDIATE PURLIN ATTACHMENT
(3 FASTENERS PER PANEL)
EAVE ATTACHMENT
(3 FASTENERS PER PANEL)
(6 FASTENERS PER PANEL
FOR HIGH WIND LOADS)
DETAIL “B”
DETAIL “A”
DEEP / STANDARD CORRUGATED
END LAP DETAIL - STEEL PURLINS
ISOMETRIC VIEW OF
DEEP / STANDARD CORRUGATED
PANEL ROOF
1
/
4
” - 14 x
7
/
8
” LAP TEK
20” O.C
1
/
8
X
3
/
8
” FOAM TAPE SEALER (OPTIONAL)
SIDE LAP NOTES:
1.
1
/
8
x
3
/
8
” tape sealer can be installed between weather inf iltration point and fastener.
2. Install 14 x
7
/
8
” Lap Tek fasteners at 20” on center.
3. When possible, install panels such that side laps are nested away from prevailing winds.
END LAP NOTES:
1. End lap tape sealer must be installed between weather inf iltration point and fastener.
2. Install 14 x 2” self-drilling fasteners on each third rib of panel (approx. two fasteners per foot).
Phone [phone] or Neighbor Islands 800-352-3920 Fax [phone]
91-104 Kalaeloa Blvd., Kapolei, HI 96707 wwwkloecknermetals.com [e-mail]
10/13
PREVAILING
WIND DIRECTION
END LAP TAPE SEALER
ROOF PANEL
6” min.