User Manual

Safety instructions
1) Do not work alone.
2) Always wear safety goggles.
3) When testing, use a safety enclosure around the test device.
4) Never stand in the plane of rotation of the propeller.
5) High currents can cause fires and burns. Use wires rated for the
current used.
6) Do not reverse polarity. Damage will occur.
7) Do not short the circuit or the power source.
8) Do not use voltages over 35V.
9) Always disconnect the power source before manipulating the
equipment.
In the calibration wizard, choose the option "Calibrate using
a user-provided test weight". Follow the instructions. Recalibrate
the device if it has been disassembled, if the wires have been
moved, or every 2 months.
1) Go to the "Utilities" tab.
2) Calibrate the thrust.
Calibration
3
5
Option A: using factory calibration coefficient
1) Go to www.goo.gl/ydok1q to install the app.
2) Launch the Chrome app from your computer.
3) Connect the device to a computer using the USB cable.
4) Press the "Connect" button in the app as seen below*.
Note: Chrome app updates are automatic.
*If a new COM port does not appear when you connect the
device (as seen in the image below), you may need to install a
driver. For driver installation support, visit:
rcbenchmark.com/installation-and-drivers/.
Software installation (Chrome app)
Press "Connect"
4
Option B: using a user-provided calibration weight
In the calibration wizard, choose the option "Calibrate using
calibration coefficient". Then, enter the calibration coefficient
on your load cell.
Install power cables
⚠
Warranty void if reversed!
Battery +
(red)
Battery -
(black)
Tie-wrap