User Manual

ManualsBrandsUnbranded ManualsHobbyRC Benchmark Thrust Stand Series 1520

INCLUDED

-Assembly manual (1)

-Measurement circuit (1)

-Motor mounting part (1)

-Lower structural part (1)

-Power cables (2 x 2.5ft)

-Load cell 5 kg (1)

-Tie-wraps (≈10)

-Hex keys (2)

-Washers to install motors

(1 bag)

-USB cable (1)

-RPM probes (1 + 1 extra)

-M5 12mm (2)

-M4 30mm (2)

-Spacers (2)

-Washers (2)

Dynamometer Series 1520

Assembly Manual 1.03

For the latest version

of the manual and

extra tutorials, please visit

RCbenchmark.com

Install circuit and load cell

Install motor mounting part

Load cell

(wires up)

Spacer (2)

Data

acquisition

board

Washer (2)

M4 30mm (2)

Lower structural part

M5 12mm (2)

Motor

mounting part

Connect load

cell, orientation

not important

Summary of content (4 pages)

PAGE 1
Install circuit and load cell Load cell (wires up) Dynamometer Series 1520 Assembly Manual 1.03 For the latest version of the manual and extra tutorials, please visit RCbenchmark.com Data acquisition board Spacer (2) Washer (2) M4 30mm (2) Lower structural part 2 Install motor mounting part INCLUDED -Assembly manual (1) -Measurement circuit (1) -Motor mounting part (1) -Lower structural part (1) -Power cables (2 x 2.
PAGE 2
3 Install power cables 5 Calibration 1) Go to the "Utilities" tab. Battery + (red) 2) Calibrate the thrust. Option A: using factory calibration coefficient Tie-wrap Battery (black) ⚠ 4 Warranty void if reversed! Software installation (Chrome app) 1) Go to www.goo.gl/ydok1q to install the app. 2) Launch the Chrome app from your computer. 3) Connect the device to a computer using the USB cable. 4) Press the "Connect" button in the app as seen below*. Note: Chrome app updates are automatic.
PAGE 3
Power system schematic 6 8 RPM probe (tap into motor signal) Secure all wires, the ESC, and the device Secure all wires and the ESC using tie-wraps or double-sided tape. Motor Secure the device to a table using c-clamps or bolts. RPM PROBE + + VIN - GND + 9 ESC - - USB VIN ESC signal (PWM) While the thrust sensor is bidirectionnal, we recommend installing the propelIer in a pusher configuration (airflow goes away from the table). Install motor To computer GND Battery/power supply MAX.
PAGE 4
10 Speed measurement In the "Setup" tab of the app, indicate the number of poles for the motor you are using. Press the icon for help on pole counting. 11 Motor and propeller testing You can manually control the motor for your tests and record your data manually or continuously. These options are available in the "Manual Control" tab. You can also use the supplied scripts in the "Automatic Control" tab to test and record motor data automatically.