User manual

User Manual
Version 1.1
2013-09-09
RaspBee ZigBee addon board
www.dresden-elektronik.de
Page 9 of 21
4.2.2. Software
 Linux operating system (Raspbian Linux distribution
1
)
 Qt4 library v4.8
 deCONZ for ARMv6 Linux
2
 GCF Flasher
3
 ZigBee firmware for RaspBee
4
(optionally)
4.3. Setup the components and start the application
1. Unpack the RaspBee unit.
2. Shutdown and Power-Off your RPi.
3. Connect the RaspBee to the RPi’s user header. Pin 1 of RaspBee (square marker) must
be connected to Pin 2 of RPi header P1 at the board edge.
Figure 3: RPi user header
Notes: Double check that the header is NOT shifted inadvertently since this may
damage the RaspBee board irreversible.
Do not connect the RaspBee if the RPi is powered since this will cause a
restart of the host device.
4. Power-On the RPi and wait until the login prompt is available.
5. Log in and acquire superuser rights.
6. Enable the access to the RPi serial port for proper communication (see Section 4.4).
7. Install all additionally required software packages (see Sections 5.1 and 5.2).
1
Refer to http://www.raspbian.org/ for download and installation instructions
2
deCONZ is available in the download area on http://www.dresden-elektronik.de
3
GCFFlasher is available in the download area on http://www.dresden-elektronik.de.
4
ZigBee firmware is available in the download area on http://www.dresden-elektronik.de. (section
deCONZ, file extension .bin.GCF).