Instructions / Assembly

6
Take one of the two(2) rubber rings and adjust it to the
top of the drain, aligning the holes carefully. Secure with
strips of adhesive tape to prevent sand from penetrang
inside the holes once the drain has been installed. Se-
cure one end of the long black or white hose inside the
drain spout. First apply glue on the drain spout and in-
side the drain end, then secure with one or two collars .
Cut the hose so that it ends with the stone dust (or
sand). Measure the pool radius from the center of the
drain, then add 15 cm (6").
4
Dig a hole 30 cm (12") wide by approximately 25 cm
(10") deep in the center of the circumference.
From the center hole to the projected locaon of the
pool motor, dig a 15 cm (6") wide trench. Place the re-
moved soil aside to be used later to cover the hose.
Place the assembled boom drain in the hole so that it is
approximately 1.3 cm (1/2") higher than the surface soil.
Bury the hose, leveling the drain as much as possible.
Compact the soil, using your feet and a tampering tool as
well.
Mix three (3) shovels of stone or sand dust with half a
shovel of pure cement, adding a small quanty of water,
then pour the cement around the drain unl it reaches
1.3 cm (1/2") from the top.
Boom Drain Assembly
Place Teon around the threaded plug. Screw in drain
holes using large pliers. Glue the connector in the appro-
priate opening.
15 cm x 15 cm (6” x 6”)
25 cm (10”)
30 cm (12”)
A
FLAT POOL DIAMETER POOL RADIUS
A B C
8' 1'-5'' 2,31m (7'-7'') 1,16m (3'-9 1/2'')
12' 1'-9'' 3,68m(12'-1'') 1,84m(6'- 1/2'')
15' 2'-0'' 4,57m (15'-0'') 2,29m (7'-6'')
18' 2'-6'' 5,44m (17'-10'') 2,72m (8'-11'')
21' 2'-9'' 6,38m (20'-11'') 3,19m (10'-5 1/2'')
24' 3'-0'' 7,29m (23'-11'') 3,64m (11'-11 1/2'')
27' 3'-6'' 8,18m (26'-10'') 4,09m (13'-5'')