Instructions / Assembly

Fill the pool up to the base of the wall before stopping and

removing the vacuum cleaner.

PUMP RETURN FITTING

Aer you remove the vacuum cleaner, you may install the

return ng.

Place the return ng ring against the liner and adjust it so

that it is perfectly aligned with the hole in the wall.

When the ring is properly posioned and secured, cut the

liner in the middle of the ring.

Insert the return ng from the inside, placing the rst

gasket between the return ng and the liner and the sec-

ond between the wall and the liner. Then ghten the out-

side ring with large pliers, taking care not to crease the lin-

er.

BOTTOM DRAIN (oponal)

Find the holes through the middle of the liner and screw

the ring and gasket in against the liner before cung the

liner in the middle of the ring, then screw on the drain cov-

er.

Install the joiner plates on top of each upright then install

metal screws at the top of the support posts, making sure

the support posts are perpendicular to the ground.

Place the top seats on top of the joiner plates and secure each

secon using four (4) metal screws. Aach the end of each top

seat secon to the surface of the top joiner plates

Top seats must be centered on the joiner plate and equally distri-

buted all around the pool.