Instructions / Assembly

7(8/%^%9%/)877,)8%/01(8%&'7( 1 001 ( &* '.
Place one 44" pressure plate on each strap end channel so that the center of the plate is even with the center
of the channel. When installing these plates the corrugation bumps should be up and the flat surface should
be down. One edge has a larger flat surface than the other. The larger flat surface should be closer to the center
of the pool. (See diagram). (KC%L<C##"<C%LA=$C%!"#$%CU$C@>%L=#$%$KC%C@>%?S%$K C% IK =@@CA% =O ?"$%6W$?P=<>#%$KC
%IC@$C<%?S%J?"<%L??A5%If you have done this correctly the two holes in the center of the pressure plate line up with
the two holes in the center of the strap end channel. Secure the plates to the channels using two #12 X ¾"
in each. Once all plates are secured to the channels, the plates should overlap each other. Secure the plates to e
other using three #12 screws in each overlapping area.
Traditional Buttress
2345%H^
Buttress-Free *
2345%H`
* All foot print are based on Buttress-Free (Yardmore) models.
Made sure to add approx.20" on the traditional model to have enough space for wrap/strut.