Installation Guide

Installation Guideline for Adhesive Wall Panel

Precautions and Warnings

Products are made with real wood presenting various designs and shades for a beautifully rich

finish. Each board is unique to give the decor a natural look.

• The product must be used on interior walls only.

• Self-adhesive wood wall panel is not recommended in places where the temperature can

exceed 50° C.(e.g. near a fireplace) nor in rooms that can become damp (e.g. a bathroom, shower

rooms). As with hardwood flooring, must be installed in a room where the humidity level remains

between 40 % and 60 %. The wood should rest flatly in its box at room temperature for at least

72 hours before installation.

• To ensure a consistent and natural result, mix the content from all the boxes before beginning

installation.

Tools Required

• Dry cloth • Level • Pencil • Hand saw or circular saw • Rubber roller • Measuring tape

Preparation

• Installation steps may vary according to the desired look. Systematically plan the layout, design

and the amount of wood necessary to complete the wall before beginning installation.

• Self-adhesive wood wall cladding adheres to several surfaces such as plasterboard (unpainted,

primed or painted), concrete, plywood or plaster walls. Ensure that the surface to be covered is

clean, dry, smooth. Uneven areas must be adjusted. Clean the wall with a dry cloth, but do not

use any cleaning products as they may affect the effectiveness of the adhesive strips.

• If the wall is freshly painted, wait until it is completely dry. We recommend a 72-hour waiting

period

• All electrical outlet and switch plates should be removed.

Common Installation (horizontal)

• Start the installation at the top of the wall. Try not to follow the ceiling line, as it may not be

leveled.

• To ensure that the first row of wood is absolutely straight, place a first board at the top of the

PAGE 1
Installation Guideline for Adhesive Wall Panel Precautions and Warnings Products are made with real wood presenting various designs and shades for a beautifully rich finish. Each board is unique to give the decor a natural look. • The product must be used on interior walls only. • Self-adhesive wood wall panel is not recommended in places where the temperature can exceed 50° C.(e.g. near a fireplace) nor in rooms that can become damp (e.g. a bathroom, shower rooms).
PAGE 2
wall using a level and mark a reference line below the piece. Next, trace a line with the level from one end of the wall to the other starting from this reference. • Remove the protective film from the adhesive strips on the back of the first board and place it following the reference line. Stick the top of the board first, then the bottom and press firmly for 10 seconds. • Repeat for each piece along the row.