Use and Care Manual

POWDER COATED SCREWS VS NAILS

FASTENMASTER LEDGERLOK

SCREW DRIVER BITS

These magnetic drivers are specially made for use with our powder coated

screws. The “hex” part of the driver is engineered to grip on the flat part of the

screw head instead of the corners. This vastly reduces chances for damage to

screw head and paint during installation. Both long and short drivers are

available for purchase.

Highest pullout values in the industry

Pullout strength = mimimum 900 lbs!

Very susceptible to pullout

Built-in grommet and washer seals

and eliminates leaks

Requires perfect installation

in hopes to avoid leaks

Powder Coated to match steel

Will inevitably rust & corrode

especially in Pressure Treated lumber

Stronger design shear values than 1/2” lag bolts

Coating Process protects against corrosion, even in pressure treated wood

Guaranteed not to rust or streak for the life of the product

IBC/IRC Code Compliant

Built in washer head eliminates the need for additional washer

No pre-drilling needed, easy to install through truss plates