User Manual

Air Brush Assembly & Instruction Manual
SAVE THIS MANUAL
You will need this manual for safety warnings, precautions, operation, inspection,
maintenance, cleaning procedures, parts mbly diagram. Keep your invoice with
this manual. Write the invoice number on the inside of the front cover. Keep this
manual and invoice in a safe and dry place for future reference.
GENERAL SAFETY WARNINGS AND PRECAUTIONS
1. Do not exceed the maximum pressure rating of 50 PSI.
2. Keep work area clean and dry. Cluttered, damp, or wet work areas invite injuries.
3. Keep children away from work area. Do not allow children to handle this product.
4. Store idle equipment. When not in use, tools and equipment should bestored in
a dry location to inhibit rust. Always lock up tools and equipment, and keep out
of reach of children.
5. Do not use products if under the influence of alcohol or drugs. Read warning
labels on prescriptions to determine if your judgment or reflexes are impaired
while taking drugs. If there is any doubt, do not attempt to use products.
6. Use eye and breathing protection. Wear ANSI approved safely impact eye
goggles and an ANSI approved dust mask or respirator when using products.
7. Industrial applications must follow OSHA requirements.
8. Stay alert. Watch what you are doing at all times. Use common sense. Do not
use products when you are tired or distracted from the job at hand.
9. Check for damaged parts. Before using this product, carefully check that it will
operate properly and perform its intended function. Check for damaged parts
and any other conditions that may affect the operation of products. Replace or
repair damaged or worn parts immediately.
10. Replacement parts and accessories: When servicing, use only identical replac-
ements parts. Only use accessories intended for use with specific product.
11. Maintain this product with care.keep this product clean and dry for better and
safer performance. For your safety, service and maintenance should be perfor-
med regularly by a qualified technician.
-2-