User Manual

-11-
PARTS LIST AND ASSEMBLY DIAGRAM
1. Protective Cap 2. Air Cap 3. Nozzle
4. Air Brush Housing 5. Hose Connector Nut 6. Valve Screw
7. Needle Adjust Screw 8. Trigger 9. Back Lever
10. Handle 11. Needle 12. Cup Lid
13. Tube Shank 14. Needle Tube 15. Needle Stop Screw
Notice: Each Air Brush may not come with all equipment or accessories listed above.
TROUBLESHOOTING
Air leaking
Valve lever stuck
Problem Possible Causes Probable Solutions
Paint leaking
Head of needle bent or distorted
Repair or replace parts
Nozzle and needle not fully contacted
Loosen screw, make sure nozzle
and needle fully contacted and
then screw tightly.
Poor paint atomization
Air bubble in the cup
Paint leaks from back
Air Brush nozzle is partially plugged
Wash nozzle with detergent
Needle screw loosen
Make sure screw is tighten
Faulty nozzle seal ring causes air
reflux
Replace nozzle seal ring or use
seal glue on whorl
The gap between needle and its seal is
enlarged
Take off parts on the back, fasten
screw or replace the seal.
Take trigger off; apply lube after
cleaning and put trigger back.