User Manual

FEATURES
*Takes use of 3X1 .5V size AA batteries
* Heats up in less thah 15 seconds
*
Cools down in less than 30 seconds
*
Can continuously operate for approx 1
hour with new batteries
*
Iron plated long life heater tip Safety cap
and tip changer
included.
How to solder
1. File off any dirt, rust or paint on the part
you wish to
solder.
2. Heat the part with the soldering iron.
3. Apply resin-based solder to the part
and
melt it with the soldering iron.
Note: When using non-resin-based solder, be
sure to apply a solder paste to the part
before applying the solder.
4. Wait for the solder to cool and harden
before moving the
soldered part.
CAUTIONS
1. * Always switch off the soldering iron
after
use by sliding the switch to the
" OFF " position
*
Place the protective cover over the tip
when storing
so that the cover secures
the slide switch in the " OFF " position
* Do not touch the tip when it is hot.
* Do not immerse in the water.
2. The first time you use the soldering iron,
it may smoke
slightly as the heating ele-
ment dries out. This is normal and
should only last for approx. 1 0 minutes.
3. Never file the
specially-plated tip.
24 757
,