Use and Care Manual

7 www.triplett.com UM-POE2000

side of the cable), Reconnecting the PSE to the tester will start auto-

rotate display.

 To perform a reset, first unplug the cable from PD side, next unplug

the PSE side cable. Reconnect the PSE side until voltage values are

displayed then connect to the PD to be tested.

 The tester cannot measure and test PD alone, it has to be connected

to a PSE first, Once this is done then connect to the PD, after

negotiation process, the tester will start power

Level testing.

Cautions:

**CAUTION**: Before connecting PD to the tester make sure that

the PD to be connected is either a standard PoE powered device

or a non-PoE powered device to avoid damaging a non-PoE

device is damaged by a non-standard passive PoE power.**

**CAUTION**: Most PoE injectors on the market are passive

injectors which means power is always on, in order to prevent

damage to the meter make sure to be aware of what type of PSE

either standard active or passive PoE you are connecting to.