Instructions / Assembly

Awesome Chair
Assembly Instructions
The slipcover is shipped separately from the interior components. These assembly instructions
assume you have received BOTH the slipcover and the interior components
CARE INSTRUCTIONS: To clean cover, remove interior parts. Wash cover in cold water by itself.
Do not use bleach. Tumble dry low heat. Replace interior parts in cover.
Interior Components Parts List
A. Backrest Cushion (1)
B. Arm Cushions (2)
C. Seat Cushion (1)
B. Arm Cushions
A. Backrest Cushion
C. Seat Cushion
Slipcover Parts List
D. Slipcover (1)
Note: Your slipcover ships folded. Before
assembling, if you would like to get out
the wrinkles, place the slipcover in a
dryer on medium heat for 15 minutes
with a damp towel, then assemble
Please familiarize yourself with the Awesome Chair slipcover’s shape
and think of placing pillows inside of pillowcases, it is a similar
procedure.
1) Locate the zipper on the bottom of the slipcover and unzip it.
2) Locate the cushion labeled “Backrest”. Place this cushion into the
slipcover so that the words “backrest front” face forward. It is
easiest to fit the sides of the slipcover to the cushion. easiest to fit the sides of the slipcover to the cushion.
3) At the base of the Back Cushion, within the slipcover, locate 2
fabric flaps with Touch Fastener on the ends. Fasten these over the
end of the Back Cushion to hold in place. Pull as tight as possible.
4) Insert the cushions labeled “Arm”. Fit them into the arm’s shapes
of the slipcover and fasten the flaps with Touch Fastener as you did
the Backrest Cushion.
5) Insert the cushion labeled “Seat5) Insert the cushion labeled “Seat Top”. Be sure that the words “Seat
Top” is facing up toward the top of the chair.
6) Zip slipcover closed. Adjust cushions so the fit well within the
Slipcover.
Thank you for your purchase.
Interior Components Diagram