Use and Care Manual

9
Starting + Stopping
mWARNING! Be sure the trigger switch is released when
changing the position of the forward + reverse selector switch.
Always store the tool in the locked/o position.
1. To start the cordless screwdriver, press the trigger switch
(Fig. 13).
2. Release the trigger switch to stop (Fig. 13).
LED Light
The cordless screwdriver is equipped with an LED light to
provide additional lighting for operation in low light conditions.
The LED light will turn on when the trigger switch is pressed
(Fig. 14). The light will go o when the trigger is released.
Storage
Bits Storage
1. 50 mm bits provided with the screwdriver can be placed in
the storage area located on both sides (Fig. 15).
2. 25 mm bits provided with the screwdriver can be placed in
the bits holder (Fig. 16).
Cleaning + Maintenance
mWARNING! To avoid accidents, always disconnect the
tool and/or charger from the power supply before cleaning.
Use only mild soap and damp cloth to clean the tool. Never
let any liquid get inside the tool; never immerse any part of the
tool into liquid.
Ventilation openings and trigger switch must be kept clean
and free of foreign matter. Do not attempt to clean by inserting
pointed objects through opening.
mCAUTION! Certain cleaning agents and solvents
damage plastic parts. Some of these are: gasoline, carbon
tetrachloride, chlorinated cleaning solvents, ammonia and
household detergents that contain ammonia.
mWARNING! No user serviceable parts inside. Preventive
maintenance performed by unauthorized personnel may result
in misplacing of internal wires and components which could
cause serious hazard.
Fig. 13
Trigger switch
Fig. 14
LED light
Fig. 15
Bit storage
Bit storage
456
PH1
PH2
PH3
PZ1
PZ2PZ3 H3 H4
Fig. 16
Bits holder