Use and Care Manual

8
3. To remove the bit, pull it straight out.
4. For bit tips, use exible bit extender. Insert the exible bit
extender into the cavity in the bit collet (Fig 8).
NOTE: Only hex end bits will t in bit collet.
5. Select the driving bit best suited for the job and insert it
into the bit extender collet (Fig. 9).
mWARNING! Do not use screwdriver as a pry bar in any
position.
mWARNING! To avoid screwdriver being turned on
accidentally, do not carry in your pocket.
Selecting the Direction of Rotation
mWARNING! Be sure the trigger switch is released when
changing the position of the forward + reverse selector switch.
Always store the tool in the locked/o position.
NOTE: Always check the direction of the cordless screwdriver
rotation before use.
1. For driving fasteners, select forward rotation. Press the
forward selector switch from right to left at against the
cordless screwdriver (Fig. 10).
2. For removing fasteners, select reverse rotation. Press the
reverse selector switch in the opposite direction (button
pushed to the right) (Fig. 11).
3. The center position locks the tool (Fig. 12).
Fig. 7
Collet
Bit
Fig. 8
Collet
Flexible bit extender
Fig. 9
Flexible bit extender
Bit extender collet
Bit
Fig. 10
Forward
rotation
switch
Fig. 11
Reverse
rotation
switch
Fig. 12
To lock
the tool
To lock
the tool