Manual

Specications

Line Voltage: 115-120 or 230-240 VAC 50/60 Hz (switchable), 130 VA

Current Draw (no load): 0.21A @ 115-120 VAC, 60 Hz or 0.10A @ 230-240 VAC, 50 Hz

Current Draw (maximum load): 0.91A @ 115-120 VAC, 60 Hz or 0.45A @ 230-240 VAC, 50 Hz

Secondary Voltage Output: 24 VAC, 50/60 Hz, 3.2A (77 VA)

Maximum Load Per Station Output: 0.75A (18 VA)

Maximum Load Per Pump/Master Valve Output: 1A (24 VA)

Automatic Action: Type 1.Y Product

Impulse Voltage: 2500V

Operating Temperature: -10°C to +60°C (14°F to 140°F)

Storage Temperature: -30°C to +65°C (-22°F to 149°F)

Ball Pressure Test Temperature: 257°F/167°F (125°C/75°C)

Glow Wire Test Temperature: 1,562°F/1,022°F (850°C/550°C)

Hardware Features

Plastic cabinetry

Front, back and top locking covers

Modular station output capacity upgradeable in 16-station increments.

Optional antenna adapter kit available.

Fuses and Circuit Breakers

Power Supply:

1.5A On/O Switch/Circuit Breaker – Main Power Input

3.2A Fuse – Power Supply (Slow Blow)

4.0A Circuit Breaker – Control Functions

Control Modules:

Station Output – 3.0A Fuse (Fast Blow, Automotive Type)

WARNING

IF FUSE REPLACEMENT IS REQUIRED, REPLACE WITH A FUSE OF THE SAME TYPE AND AMPERAGE

RATING. FAILURE TO COMPLY CAN RESULT IN SERIOUS INJURY AND/OR EQUIPMENT DAMAGE DUE

TO FIRE HAZARD.

Electronic Compatibility

Domestic: This equipment generates and uses radio frequency energy and if not installed and used properly, that is,

in strict accordance with the manufacturer’s instructions, may cause interference to radio and television reception. It

has been type tested and found to comply with the limits for a FCC Class B computing device in accordance with the

specications in Subpart J of Part 15 of FCC Rules, which are designed to provide reasonable protection against such

interference in a residential installation. However, there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause interference to radio or television reception, which can be determined by

turning the equipment o and on, the user is encouraged to try to correct the interference by one or more of the following

measures:

• Reorient the receiving antenna.

• Relocate the irrigation satellite with respect to the receiver.

• Move the irrigation satellite away from the receiver.

If necessary, the user should consult the dealer or an experienced radio/television technician for additional suggestions.

The user may nd the following booklet prepared by the Federal Communications Commission helpful:

“How to Identify and Resolve Radio-TV Interference Problems.” This booklet is available from the U.S. Government

Printing Oce, Washington, DC 20402. Stock No. 004-000-00345-4.

International: This is a CSPR 22 Class B product.