Instruction Manual Model:W 100049057 I | Thank you for choosing our products! Please take the time to read and familiarize yourself with the proper installation steps described on the following pages. During the installation process of this cabinet, you need to use an electric drill, screwdriver and hammer. You need to prepare in advance. The above installation tools are not included in this product.
IMPORTANT a DILUTE Tip over hazard: secure the safety! The cabinet can be tipped over by children or adults, so we suggest that you could mount the cabinet on the wall. Do not move this cabinet using its handle. Left back plate © Top plate © Right back plate © Bottom square tube /] © Let side plate @ Foot mats O Right side plate © Shelf A*a pes B*26 pcs C*6 pcs (expansion screws) pcs E*4 pcs F*3 pcs (foot mat) (handle) G*3 pes H*6 pcs {rubber buffer) (magnetic lock) <3 = Tips: X4 pos 1.
ae Lift the five metal buckles on ® inwards by about 45° and insert them into the corresponding holes of then press the metal buckles down to lock © and @, @ Install in the same way. Press the convex corners on both side of the magnetic lock to divide the magnetic lock into two parts, insert them into the corresponding holes of ® from the front and back respectively, and insert the rubber buffer into the corresponding holes, as shown in the figure below, ® Install in the same way.
TEETER Te RE DEL Tips: The cabinet comes with four adjustable or removable feet to prevent scratching the floor. The stability of the cabinet can be improved by adjusting the foot mats.
Step 7 Cabinet Interior shelves Installation §— side metal buckle © onetime nude Image-1 Put ® into the cabinet at an angle (as shown in image-1), put the front end into the openings on both sides (as shown in image-2), and raise the back so that both sides of enter the supports on the inside of @ and @ respectively (as shown in image-3), then flatten the back of ®, pry the metal buckles on both sides inward, and push up the two metal buckles in front, and use the same method for the other shelf.
Feel TL middle baffle hole hole inside baffle hole shaft hole #: stop drawers from falling oO © ® handing convex 3 » lock buckle Pry the 6 metal buckles on both sides of @ inward by about 45°, and insert the mounting ears at the bottom of ( into the hanging holes of @, as shown in the figure (note that) is on the inside of align the metal buckles of @ with the holes of @, and then upward Press the metal button, and then press the lock into the corresponding lock hole, so that and @ are locked, and @ is inst
