Installation Guide
Table Of Contents
- Install_NX58R4311SS_AA_DG68-01153A-00_EN.pdf
- Before you begin
- Safety instructions
- Safety symbols
- Important safety precautions
- Gas warnings
- California Proposition 65 Warning
- In the commonwealth of massachusetts
- Electrical warnings
- Grounding instructions
- Installation warnings
- Surface burner warnings
- Oven warnings
- Electric warming drawer or lower storage drawer warnings
- Self-cleaning oven warnings
- Proper cooking of meat and poultry
- Gas range components
- Installation requirements
- Tools and materials
- Installation instructions
- Install_NX58R4311SS_AA_DG68-01153A-00_MES.pdf
- Antes de comenzar
- Instrucciones de seguridad
- Símbolos de seguridad
- Precauciones importantes de seguridad
- Advertencias sobre el gas
- California Proposición 65 Advertencia
- En el estado de Massachusetts
- Advertencias sobre la electricidad
- Instrucciones de conexión a tierra
- Advertencias sobre la instalación
- Advertencias sobre los quemadores superiores
- Advertencias acerca del horno
- Advertencias sobre el cajón de calentamiento eléctrico o el cajón de almacenamiento inferior
- Advertencias acerca de la autolimpieza del horno
- Cocción correcta de carnes de res y de ave
- Componentes de la estufa a gas
- Requisitos de instalación
- Herramientas y materiales
- Instrucciones de instalación
- Install_NX58R4311SS_AA_DG68-01153A-00_CFR.pdf
- Avant de commencer
- Consignes de sécurité
- Symboles de sécurité
- Précautions importantes relatives à la sécurité
- Avertissements concernant le gaz
- CALIFORNIA PROPOSITION 65 Avertissement
- Dans le Commonwealth du Massachusetts
- Mises en garde relatives aux risques électriques
- Consignes de mise à la terre
- Avertissements relatifs à l'installation
- Avertissements concernant les brûleurs de surface
- Avertissements concernant le four
- Avertissements concernant le tiroir chauffe-plat électrique ou le tiroir de rangement inférieur
- Avertissements concernant le four auto-nettoyant
- Cuisson appropriée de la viande et de la volaille
- Composants de la cuisinière à gaz
- Conditions d'installation
- Outils et matériel
- Consignes d'installation
30 English
Installation instructions
Installation instructions
To adjust ame low setting
Identify which burner is exhibiting too high or too low of simmer rate via
manifold panel graphics.
Simmer Set
Screw
1. Rotate a knob to “LO” position and
remove the knob from the valve shaft
while the ame is lit.
2. Carefully push the screw driver into
the C chanel of the valve, until it his
the simmer set screw. Make sure the
screwdriver athead is seated into the
set screw groove.
3. Rotate valve set screw clockwise to decrease “LO” setting ame output, or
rotate set screw counter clockwise to increase “LO” setting ame output.
WARNING
1. Do not completely remove the valve set screw from the valve stem. The valve
set screw is an integral part of the gas valve assembly. Removing the valve set
screw will cause gas to leak.
2. After adjusting the valve set screw, inspect the assembly for gas leaks.
Memo
Install_NX58R4311SS_AA_DG68-01153A-00_EN.indd 30 2019-01-22 2:27:58