Product Brochure

Low Profile
Made in USA - Patented
P-tec Products, inc.
P 616-772-0659
F 616-772-1480
[e-mail]
www.p-tecproducts.com
Attention! Face plate must
be installed flush so that doors
close completely when not in
use. Uneven installation will
create a poor seal for doors.
Benefits that others cannot provide
Closed position (not in operation)
• Birds and other pests cannot enter the “Exclusive Dual Door” design.
• Reduces energy robbing drafts from entering the residence through the vent.
• Clean look, fully closed design, no place for bees or wasps to nest.
Open position (in operation)
• Most efficient air flow vent in the industry for reduced clothes drying time.
• No screen or guard to collect lint, plug-up and reduce air flow efficiency.
• Reduces dryer fire hazard caused by lint buildup.
Maintenance - Annual duct cleaning recommended
• Ducts can be cleaned with lint brush from either side.
• Makes multi-story installation cleaning possible from the
inside without using ladders.
• Tough U/V resistant plastic resists sunlight and cracking.
Compare the No Pest Vent to our competition
• Vents with one-piece flap or 2 to 4 louvers.
∗ Opening with their beaks, birds quickly build a nest for a well heated home.
∗ Lint buildup causes unreliable louver closure allowing drafts and easier entry for birds.
• Vents with screen, floating shuttle, or add-on guards for existing vents.
∗ Require weekly or monthly cleaning of lint buildup.
∗ Lint buildup restricts flow which reduces dryer efficiency and creates a fire hazard.
Features
• Includes 4 inch diameter 12 inch long duct pipe.
• Used for clothes dryer, bathroom and stove/range hood exhaust vents.
Installation
♦ Assemble tube and attach to faceplate with seam oriented up (see Figure 1).
♦ Insert tube thru hole in building.
♦ Fasten faceplate to building with screws using concealed mounting pattern (see Figure 1).
V110414
Most Efficient
Maintenance Free
Vents on the Market
Attention! Insert
pipe with seam at top
to avoid interference
with inner door.
Note! Use #8 stainless steel screw
in concealed under hood locations.
Do not over tighten
Figure 1.