Warranty

9
ASSEMBLY INSTRUCTIONS
Hardware Used
II
JJ
KK
9
10
9. WARNING:Remove protective cover before
assembling.
Note: If necessary for proper alignment of reflector
sections, loosen each bolt prior to further assembly
and retighten after sections are aligned.
10. Attach reflector panels (A) together using
M6 X 10 mm screws (JJ) and Φ6 washers (II).
Secure loosely with cap nuts (KK).
x 3
x 3
x 3
Φ6 Washer
M6 X 10 mm Screw
B
A
8
Cap Nut
KK
II
JJ
Lowes.com
Hardware Used
HH
x 4
3/16” Screw
HH
8. Connect the upper and lower poles. Put the gas hose
and regulator through lower pole. Connect the upper and
lower poles with 4 3/16” screws (HH). Before tightening,
make sure the control knob on the head assembly is facing
front, same side as the door on the cylinder housing.