Warranty

ASSEMBLY INSTRUCTIONS

14. Screw gas hose and regulator (E) onto prop ane

cylinder (not included). Do not cross-thread.

Place the propane cylinder into the cylinder housing (F),

faste n cylin der with propane tank strap, then close the

door. The propane gas and cylinder are sold separately.

Use a standard 20 lb. propane cylinder only

(approximately 12.2 in./31cm in diameter and 17.9 in.

/45.5cm h igh). Use this heater only with a propane vapor

withdrawal supply system. See chapter 5 of the standard

for storage and handling of liquefied petroleum gas,

ANS/NFPA 58. Your local library or fire department

should have this book. Storage of an appliance indoors is

permissible only if the cylinder is disconnected and

removed from the appliance. A cylinder must be stored

outdoors in a well-ventilated area out of the reach of

children. A disconnected cylinder must have dust caps

tightly installed and must not be stored in a building,

garage or any other enclosed area. The maximum inlet

gas supply pressure: 250 psi/1750 kPa. The minimum

inlet gas supply pressure: 25 psi/175 kPa. Manifold

pressure with regulator provided: 11 inch W.C/2.74 kPa.

The pressure regulator and hose assembly supplied with

the appliance must be used. The installation must conform

with local codes, or in the absence of local codes,with

national fuel gas code, ANS Z223.1/NFPA54, natural gas

and propane Installation Code, CSA B149.1, or propane

storage and handling code, B149.2.

Lowes.com