Warranty

9
ASSEMBLY INSTRUCTIONS
Hardware Used
II
JJ
KK
9
10
9. WARNING:Remove protective cover before
assembling.
Note: If necessary for proper alignment of reflector
sections, loosen each bolt prior to further assembly
and retighten after sections are aligned.
10. Attach reflector panels (A) together using
M6 X 10 mm screws (JJ) and Φ6 washers (II).
Secure loosely with cap nuts (KK).
x 3
x 3
x 3
Φ6 Washer
M6 X 10 mm Screw
B
A
8
8. Connect the upper and lower poles. Put the gas hose
and regulator through lower pole. Connect the upper and
lower poles with 4 3/16” screws (HH). Before tightening,
make sure the control knob on the head assembly is facing
front, same side as the door on the cylinder housing.
Cap Nut
KK
II
JJ
Lowes.com
Hardware Used
HH
x 4
3/16” Screw
HH