Installation Guide

VOLPA: INSTALLATION GUIDE 1PAGE:

SILICONE SEALANT

TAPE MEASURE PHILLIPS SCREWDRIVER

BATHROOM VANITY

INSTALLATION GUIDE

PLEASE NOTE:

• LICENSED PROFESSIONAL INSTALLATION RECOMMENDED

• PRIOR TO INSTALLATION PLEASE CHECK ITEMS RECEIVED & REPORT

ANY MISSING ITEMS TO YOUR RETAILER IMMEDIATELY.

• PROTECT ALL SURFACES FROM SHARP OBJECTS, HIGH HEAT SOURCES,

DIRECT PROLONGED SUNLIGHT & CHEMICAL HAZARDS.

• CABINET CAN TIP OVER IF NOT PROPERLY SECURED TO THE WALL

POSSIBLY CAUSING INJURY OR DEATH.

DISCLAIMER:

Instrucons, drawings, and diagrams contained in this manual present

informaon available at the me of prinng. Although every aempt has

been made to keep them up to date, Volpa USA reserves the right to implement

product changes without further noce.

Li the counter (using two people for counters

50” or larger) from the front side, leaving the

back side on the boom of the box. Bring to a

vercal posion.

Remove counter from the box while maintaining it’s vercal posion. It is acceptable to use the sink openings as grasp locaons, but

highly preferable to also support it from the boom. The vercal posion must be maintained during the enre moving process.

DRAWER INSTALLATION REMOVAL OF THE DRAWER

CONTINUED NEXT PAGE

REQUIRED TOOLS - NOT IN BOX

HOW TO HANDLE YOUR COUNTER TOP

HOW TO REMOVE / ADJUST DRAWER

DANGER: POSSIBILITY OF TIP OVER

PAGE 1
BATHROOM VANITY INSTALLATION GUIDE PLEASE NOTE: DANGER: POSSIBILITY OF TIP OVER • LICENSED PROFESSIONAL INSTALLATION RECOMMENDED • PRIOR TO INSTALLATION PLEASE CHECK ITEMS RECEIVED & REPORT ANY MISSING ITEMS TO YOUR RETAILER IMMEDIATELY. • PROTECT ALL SURFACES FROM SHARP OBJECTS, HIGH HEAT SOURCES, DIRECT PROLONGED SUNLIGHT & CHEMICAL HAZARDS. • CABINET CAN TIP OVER IF NOT PROPERLY SECURED TO THE WALL POSSIBLY CAUSING INJURY OR DEATH.
PAGE 2
CONTINUED PREVIOUS PAGE SIDE ADJUSTMENT HEIGHT ADJUSTMENT DEPTH ADJUSTMENT HOW TO ADJUST HINGES ADJUST HEIGHT ADJUST LATERALLY ADJUST DEPTH REMOVE INSTALL HOW TO INSTALL A WALL MOUNTED CABINET 1 THE RECOMMENDED HEIGHT OF A WALL MOUNTED VANITY IS 32” TO 34” INCHES ABOVE THE GROUND. MEASURE A COMFORTABLE HEIGHT ACCORDING TO YOUR NEED AND MARK IT ON THE WALL. 2 LOCATE THE STUDS ON THE WALL. STUDS ARE GENERALLY SPACED 12”- 16” APART ON THE WALL.
PAGE 3
PLEASE NOTE: Plumbing parts are not included. We recommend consulting with a license plumber prior to installation. All plumbing parts (not including the vanity & items in the packing list) shown in the diagrams can be purchased at any hardware store. Your items may appear slightly different from illustrations. ln most cases your sinks are going to be pre-attached to the counter top, however, many models come with separate sink/s to be attached to counter top.