Manual

6
Pattern scanning machines to run the ball through the menu, the trajectory is stored down by power-on action, free
movement, alarm linkage, etc. to call the stored scan line.
13. Continuous scan
Just an external command or through a power-on action, free movement, alarm linkage, etc. to call, can make the
ball machine horizontal direction to a certain speed the cycle of continuous scanning.
14. Batch Scanning
Just an external command or through a power-on action, free movement, alarm linkage, etc. to call, can make the
horizontal direction the ball machine cycle of a certain speed intermittent scan.
15. Area scan
Just an external command or through a power-on action, free movement,
alarm linkage, etc. to call, can make the ball machine horizontal direction to a certain speed, within the limits set by
the community and from scanning.
Chapter 2 Equipment installation
2.1 DIP switch setting
Four DIP switch is the baud rate and the control protocol switch.
Eight DIP switch is the address code setting switch
DIP switch to “ON” means to “1”, DIP switch to "OFF" means "0".
The baud rate and control protocol as the following table:
NO. 1 2 3 4
Baud rate
OFF OFF PELCO-P