User Manual

camera. At this moment, the red LED flash fast. When you move the switch to the
middle position, the camera will stop recording the videos and save the files.
Note: When you move the switch from middle position to lower position, from lower
position to middle position, make sure there is at least 5 seconds between those two
actions. You should give camera enough time to respond. If you many instructions to
the camera in short time, it may make the camera control logical mess, and destroy
the record video files.
This HDMI cable does not support the high voltage receiver; the power supply of the
receiver should be 4.8V to 6V. Beyond this range, it may burn the module.
Without receiver control signal, the LED flashes about 4 times every second, you can
check whether the receiver is power or not, or whether you turn on the radio.
FPV-Cable-002 is applicable to Sony NEX-5, 5N, 5R, 5T, 5TL, 6R, 7N, 7R, Nikon
D90 D3X.
FPV-Cable-016 is applicable to Sony A5000/A6000.
How to Install the Optical Fiber Cable and Set on the camera
1. Put the optical fiber cable through the two holes on the sides of the infrared LED.
We suggest the cable should be next to the LED, and cut about 1mm of the cable
outside.