Instructions / Assembly

ADJUSTABLE PIPE FLASHING #MF3RTC
INSTALLATION GUIDELINES
These basic installation guidelines are for use with typical or standard applications. It is always recommended to seek advice from a licensed
professional, and to check with your local building inspector or building permit office for approvals and possible variations that may apply.
CAUTION!
Working above grade is inherently dangerous, be sure that proper fall protection measures are in place.
When working with power tools and sheet metal, gloves and eye protection are absolutely required.
Adjustable EDPM Pipe Flashing for 1/4 inch to 5 inch outside pipe diameters
1. Cut flashing boot at appropriate pipe
diameter marking.
2. Slide flashing down over the pipe 3. Apply sealant on the uderside of the
flexible aluminum base
4. Press flashing base into contours
of panel configuration
5. Fasten with self-drilling fasteners
1 2
4 5
3