Instructions / Assembly

24"
36"
2
1
4
"
3
4
"
7
1
2
"
C
L
Mark center of holes
4" min.
6" min.
Anchor Bolt
Center Upright
Outer Upright
Outer Upright
SURFACE AND IN-GROUND MOUNT INSTALLATION PROCEDURES
Step 1:
Determine installation location. Verify concrete footing is a minimum of 36" long x 24" wide x 6" thick. If the concrete pad is at an angle, steel washers
are required to act as shims. (Shims not provided) (
If a In-Ground appearance is desired recess the concrete pad 4" below finished grade
)
Allow concrete to cure per concrete manufacturers guidelines.
Step 2:
With two people place the Uprights individually onto the concrete pad and mark the center of the holes on the surface mount plate. Use the diagram
below as a guide for Upright placements. After you have made your marks, set aside the Uprights in order to drill for anchor holes. With a hammer or
rotary drill, drill through concrete at marked locations. Drill to a minimum depth of 4". (
A 3/8" masonry drill bit will be needed
)
Step 3:
Place the Uprights back over the drilled out holes. Insert provided anchor bolts into aligned holes. Position anchor nut so that it is flush with the top of
the bolt. Pound anchor bolts into the hole until the anchor washer is flush with the upright bases. Tighten anchor bolts until they are snug. Cover
remaining bolt sections with provided plastic caps.
Step 4:
Verify the correct placement, levelness, plumbness, and finished height of the instrument. Also check for sufficient clearance around the instrument.
A 36" radius is recommended around the instrument for wheelchair accessibility, however this is not required for instrument function. Instrument may
be installed next to a wall or in a variety of different configurations. Refer to sheet 5 of 5 for Chime Assembly installation.
Step 5:
If installing onto wet concrete, us the wet set anchor manufacturers guidelines for installation procedures.
PROPRIETARY AND CONFIDENTIAL
THE INFORMATION CONTAINED IN THIS
DRAWING IS THE SOLE PROPERTY OF
FREENOTES HARMONY PARK. ANY
REPRODUCTION IN PART OR AS A WHOLE
WITHOUT THE WRITTEN PERMISSION OF
FREENOTES HARMONY PARK IS
PROHIBITED.
FREENOTES HARMONY PARK
194 BODO DRIVE, UNIT F
DURANGO CO 81303
TEL: (970) 375-7825
FAX: (970) 247-0856
EMAIL: INFO@FREENOTESHARMONYPARK.COM
WWW.FREENOTESHARMONYPARK.COM
SHEET 3 OF 5
SCALE: 1:10
PRODUCT SHEET / INSTALLATION GUIDE
MANTA RAY 2016