Product Literature

Diagnostic and Radio Settings
The Diagnostics function of the Lynx Smart Satellite allows for easy system troubleshooting. Within this
function, the user can monitor the satellite’s internal voltages as well as check the satellite’s firmware version.
Use the Input Dial
to navigate through the menus while in the Menu: field.
Menu: Link Monitor – Monitors the satellite’s communication traffic.
Menu:
Sta#: 001-001
Naks: 000 Msg#: 000
FE: 000 Other:000
Link Monitor
Menu: System Monitor – Monitors all the network’s communication traffic.
Menu:
Sta#: 000-000
System Monitor
Menu: Revision – Displays the satellite firmware version, creation date and faceplate hardware
version.
Menu:
Revision: 1.00p29
Rev date: 06/07/16
VP bl ver 1.00 10/04/12
TM Hardware Ver: 3
Revision
Menu: Power-Up Detect – Displays the number of detected stations, number of detected sensors. It will
also display the date and time of the last power-down (PD) and power-up (PU).
Press the Down arrow
to scroll down the informations.
Menu:
Detect: 32sta, 00sen
PD 05/03/16 15:00:00
PU 05/03/16 15:16:07
Slot 1 card: Output
I2C Events: 000 000
Reset type: 11
Wire line found: No
Radio Anlg Enble: Yes
PowerUp Detect
Menu: Seq Stations – Activates all the stations sequentially. Use the Input Dial to set the
time duration from 0.01 sec, 0.1 sec, 0.5 sec, 1 sec, 5 sec, 10 sec, 1 min or 5
min. The user can observe the operation of each station when troubleshooting
the system using this option.
Menu:
On each for: .5 sec
Press
to start
End Station: 32
Seq Stations
Menu: Station Test – Test individual stations. Press the Down arrow to access the station
number field. Select the station you want to test and press START key
. You
can step to the next or previous station number by using the Input Dial
.
Menu:
Sta: Pump 0.000 Amp
Press
to start
Station Test
23