Product Literature

Station Based Flow Management
The SBF (Station Based Flow) screen can be accessed from the Scheduled Watering menu.
Follow the steps to access.
SBF List Event 001
Start 12:00am S22
Run 00:10:00 P26
Program Start (80)
Indicates the Event Number
Indicates the Start Time followed by the Station Number
Indicates the Runtime [Hrs:Min:Sec] followed by the Program Number
Indicates Miscellaneous Function Code
1. Press the Scheduled Watering Key . The cursor is initially located at the program selection field. Use the
Input Dial
to select SBF List which is located before P01 and after P64.
Note: The SBF List is only available after a successful download from Lynx or SitePro Central Controller.
2. Press Right
to navigate to the event number.
3. Use the Input Dial
to select the event number you want to review.
Note: Editing the SBF List is not allowed in the satellite level. SBF modifications must be made in Lynx or
SitePro Central Controller and downloaded back to the satellite to update.
Manual Watering
The Manual Watering functions are used for additional watering if the irrigation program is not sufficient.
They can also be used to troubleshoot each station for proper operation. Pressing the Manual Watering Key will
access three manual irrigation functions; Multi-Manual, Syringe and Program.
M-Manual
Select M-Manual to activate a station or group of stations with a specified runtime.
Manual station activation example: Activate stations 1–12 with a runtime of 5 minutes each and limit watering to 3
stations simultaneously.
Manual: M-Manual
Sta#: 01-12 00:05:00
Sta#: ----- --:--:--
Simult: 03
Press
to water
M-Manual
Note: The Multi-Manual function is limited to the maximum simultaneous station settings of the satellite. In cases
where a program is running and a multi-manual activated, the satellite will activate all stations specified in the multi-
manual in addition to the currently activated stations. Thus, the multi-manual will allow the satellite to exceed the
maximum simultaneous station settings.
1. Press the Manual Watering key
.
2. Use the Input Dial
to select M-Manual.
3. Press Down
to navigate to the Sta#: field. Use the Input Dial to select the value of the first
station being irrigated. For this example, select station 01.
4. Press Right
to navigate to the next station value. This value will indicate the last station of the range. If
irrigating only one station, this value should be the same as the first value. Use the Input Dial
to
set the range. For this example, select station 12.
5. Press Right
to advance the cursor to the runtime field. Use the Input Dial to set the desired
runtime. For this example, set the value to 00:05:00.
20