Manual

2
ACME read Notes
e ACME thread golf sprinkler body requires an ACME thread swing joint for connection to the piping system. e ACME
swing joint has an o-ring on the exit tting that provides a water-tight seal inside the sprinkler body when properly assembled.
!
CAUTION: With the ACME tting, do not use thread sealants such as
Teon™ tape or pipe dope.
!
Important! For ease of assembly and to ensure proper sealing, moisten the
o-ring with clean water just prior to installation.
To Install Sprinklers:
Screw the sprinkler body clockwise onto the ACME swing joint exit tting until
it stops. No further adjustment is required. If body alignment is necessary, the
sprinkler body can be loosened up to one full turn.
!
CAUTION: Leakage between the swing joint exit tting and the
sprinkler body may indicate that the o-ring is improperly seated, missing,
damaged and/or the sprinkler body is not completely installed.
If leakage is observed, perform the following procedure:
1. Shut o and relieve system water pressure.
2. Remove the sprinkler from the swing joint tting.
3. Verify that the o-ring is undamaged and is properly seated in the o-ring
groove. (Replace the o-ring if necessary.)
Moisten the o-ring with water, reinstall the sprinkler, repressurize the system
and check for leakage.
ACME Thread
Swing Joint
Exit Fitting
O-Ring
Sprinkler Body