Warranty

Zen Hot Tubs
121 S. 39
th
Ave. Suite 2
Phoenix, AZ 85009
866-939-0851
 Many troubleshooting inquiries can be handled by your dealer by phone.
 Side panel removal allows easy access to all interior spa plumbing for easy inspection or
repair, allowing for total jet accessibility in seconds rather than minutes.
 Most parts are readily available from the factory, if not already in stock at your local
dealer.
Quick Tip Guide
1. For hook up, use a dedicated circuit (15 Amp minimum, 20 Amp recommended) within
the cord distance.
2. Spa cover must be closed for the spa to properly heat. Heating time depends on air
temperature but generally the spa will average 24 to 48 hours to heat. The spa will
automatically filter twice a day for 1/2 hour each time. The pump will continue to run
until reaching the set temperature. The spa cord has a GFCI protection device. If it
repeatedly trips, disconnect the plug from the receptacle until the fault has been
identified and corrected by a spa technician.
3. If an extension cord is used, it must be as short as possible and at least 10 gauge (for
outdoor use). Inferior cords may cause spa controls to malfunction and void your
equipment warranty.
4. The heating spa will cause condensation to form on the outside and bottom of the spa
which may cause reason to believe the spa is leaking. For this reason, small “leaks”
should be allowed a few days prior to further investigation.
5. The spa pump has an automatic high temperature shut off. If the motor stops, it will
auto start after it cools.
6. All tubing, manifolds, valves, etc. can be easily accessed throughout the spa by
removing the panels.