Installation Guide

Programming Code (PC)
11
■
Function Programming
USER Code (UC)
Add New User Code
Enter PC
1
Enter New UC
Remark :
Up to 6 sets of User Code can be saved. User Code should be 4-10 digits in length.
Delete An Existing User Code
Enter PC
2
Enter the UC
you want to
delete
Delete All User Code At once
Enter PC
3
Remark : Auto-locking and Keypad locking function will be invalid when User Codes
are deleted. The lock can only be operated by key during the time.
Change Programming Code
Enter PC
4
Enter New PC
Toggle Autolock On/Off
Enter PC
5
Remark : The preset delay-time is 30 seconds, you can change the time by following
instruction.
Repeat the steps to cancel the Auto-locking function.
12
Programming Code (PC)
USER Code (UC)
Enter PC
6
Set Autolock Time Delay
Enter Seconds
(10~99)
Remark : 10-99 seconds delay-time available.
Toggle Mute On/Off
Enter PC
7
Remark : Repeat same steps to turn beeper On/Off.
LED illumination is still functioning when it's in mute.
But there will be no any warning alarm.
Enable/Disable All User Code
Enter PC
8
Create a disposable User Code
Enter PC
9
Enter new
disposable
UC
Remark : Auto-locking and Keypad locking function will be invalid when User Codes
are disabled. The lock can only be operated by key during the time.
Repeat the steps to enable the User Codes again.
Restore all preset lock settings
Press
R
Remark : Press “R” button for over 5 seconds, the programming will complete after
you hear 3 long beeps.
Remark : Disposable code will be no longer valid once being used.