Full Product Manual

13
Maintenance:
CLEANING INSTRUCTIONS: When cleaning, make sure you have unplugged the lighting
xture and allow it to cool to room temperature. Do not open the retaining clips when
cleaning. The lighting xture can be cleaned with a feather duster or a soft damp cloth.
You should plug in the lighting xture after it has been completely dried.
Other Accessories:
The lighting xture is provided with a plastic cap and a cable bushing. Always refer
to a qualied electrician if re-wiring of power cable is required. After re-wiring, the
plastic cap is used for covering the original opening for the power cable, and the cable
bushing is used for output of the power cable / hardwire.
Troubleshooting:
Issue Cause Remedy
The light is
not working
The light is not plugged in or the Main
switch is OFF
Plug in and turn on the Main switch
The ambient light sensor is ON and it
switches OFF the light while the ambient
is bright
Change the Switches 5 & 6 to OFF, or
other appropriate settings
The light is
always ON
Continuous movement
in the detection zone
Change Switches 1 & 2 settings to
shorter distance, such as Very Near
Motion sensor has been switched OFF
Change Switches 9 and 10 to other
appropriate settings
The total time the light stays on for is
Time Until Dim plus Time Until O
Adjust Switch 3 & 4, and Switch 9 & 10
settings to shorter durations
The light is ON
without any
identiable
movement
Movement occurred (movement behind
wall, movement of a small object in
immediate lamp vicinity, etc.)
Change Switches 1 & 2 settings to
shorter distance, such as Very Near
The light is not ON
despite movement
Rapid movements are being suppressed
to minimize malfunctioning of light or the
detection zone you have set is too small
Check Switches 1 & 2 settings
The ambient light sensor is ON and it
switches OFF the light while the ambient
is bright
Change the Switches 5 & 6 to OFF, or
other appropriate settings