Installation Guide

● To enable Night Vision (Black USB Plug or Bluetooth Speaker only)
○ Open the LizaCam app on your phone
○ Select applicable camera with night vision capabilities
○ Press the button highlighted in red (example below):
○ Allow a few seconds for the infrared bulbs to turn on.
○ Your night vision will be enabled!
To reset the Wi-Fi you need to reset the plug.. There are two tiny holes on the side: one has lights for
indicators and one is a reset button. When it is plugged in and the lights are on, take a pin (there should
be one in the box..) and push in the reset button. HOLD THE PIN IN and wait until the light goes off AND
KEEP IT HELD IN until the lights go back on for another 2-3 seconds, then release the pin. The camera
should reset to set up mode where you would need to go to the Wi-Fi settings on your phone, connect to
the camera's Wi-Fi, then continue the setup.