User Manual

5. Clock of LPD6812, LPD1883, and LPD1886 must be set to 1.13M or
1.04M; clock of TM1812, LPD1882, WS2811, TM1829, TM1926 and
TM1914 and some other same time sequence chips must be set to
0.78M, 0.73M or 0.39M.
Ⅴ. Special function and LCD prompt
1. Encode for DMX512 lamp. Clock is fixed and standard clock, so
LCD doesn’t display clock setting, but display “－Stop + Encode”,
means press “+” to start encoding, press “－”to stop encoding.
2. For single line chip, “Port Out Mode: 485” means using RS485 to
output differential signal, “Port Out Mode: 245” means using 245 to
output TTL signal.
3. When output four ports, ports 5 to 8 are backup of port 1 to 4.
4. On the lower right corner of brightness display page, “AC” means AC
power supply, has synchronization function; “DC” means DC power
supply.
5. Displaying “Please insert SD” means didn’t insert SD card, or didn’t
insert properly.
6. “Reading……” means reading SD card.
7. “Not DAT File” means SD card doesn’t have valid DAT file inside.
8. “Used time over” means controller has been encrypted and use time is
over.
9. “Port number err” and “Pixel is too much” display together, means