User Guide

MBI6023, MBI6024, INK1003, LX1003, LX2003, LX2006, TLS3001,
TLS3002, etc.
The type of LED driver chip must be set in software, the same-timing
sequence driver chips share an option.
For LPD6813 and P9813, H802SE drives maximum 4608 pixels, for
other chips, H802SE drives maximum 6144 pixels.
3. Clock Settings
Clock frequency can be set in software as well as in controller.
The following single-line driver chips: UCS1903, UCS1909, UCS1912,
WS2811, TM1812, TM1809, TM1804, TM1803, APA104, P9823,
INK1003 and LX1003 share the same timing sequence option and you
must choose TM1812 when setting the IC type in software. The clock
frequency of chips mentioned above is separated into two kinds: the high
frequency is 0.8MHZ; the low frequency is 0.4MHZ.
For LPD1882 and LPD1889, choose LPD1882 when setting the IC
type in software and clock frequency is 0.8MHZ.
Clock frequency of TLS3001 is recommended less than 0.8MHZ.
Clock frequency of DMX512 is fixed at 250KHZ.
If the lamp is blinking, flicking or uncontrolled, please decrease the
clock frequency. However, you can increase the clock frequency to get
smooth visual effect.
4. Performance