User Manual

H801SC, flashes twice is H802SC，after that, the indicator will light

normally. The indicator light will flashes every one second if there are

too many pixels or the DAT file is incorrect.

5. I f you want to change the SD card with power-on, please turn the

fourth, fifth dial switch on, the indicator light will flash per two

seconds at the same time. Turn the fourth, fifth dial switch off, the

controller will continue working.

6. Set passwords. In “LED Control Software” light model window, click

menu “setup” —“controller password”, pop up the encryption dialog

box, the encryption method is to limit the number of power-on time.

7. If you set the scanning frequency in “LED Control Software”, the

range is 0.2M – 7.5M.

8. When control the DMX512 lamps, the data is not output via 245 but

RS485. The ports are named as DMX_OUT1 and DMX_OUT2.

4. Dial Switches Settings

1. Switch one to three are used to set the clock frequency, switch four is

to set the enable function of switch 1 and switch 3, that is to say, if set

switch 4 to “OFF”, switch 1 to switch 3 are invalid, if set switch 4 to

“ON”, you can use switch 1–3 to set the clock frequency. The

frequency will be effective after power-on or inserting the SD card.

Dial Switch

Clock Frequency

0.2M

0.5M

1.5M