User Manual

ManualsBrandsUnbranded ManualsEnergy SavingLED Standalone Controller H802SC (2048 px)

H80ⅹSC INSTRUCTIONS

1. Introduction

H80xSC includes H801SC and H802SC, they are synchronized with

AC power supply. H801SC has one output port, only PORT1 or

DMX_OUT1 can be used, controls maximum 1024 pixels; H802SC has

two output ports, each port can control 1024 pixels, when controls P9813

and LPD6813, each port can control maximum 768 pixels.

At present, the controllable driver chips are as follows: LPD6803,

LPD8806, LPD6813, LPD1882, LPD1889, DMX512, P9813, UCS6909,

UCS6912, UCS1903, UCS1909, UCS1912, WS2801, WS2803, WS2811,

DZ2809, LPD2ws5109, SD600, SM16716, TLS3001, TM1812, TM1809,

TM1804, TM1803, DM413, DM114, DM115, DM13C, DM134, DM135,

DM136, 74HC595, 6B595, MBI5001, MBI5168, MBI5016, MBI5026,

MBI5027, TB62726, TB62706, ST2221A, ST2221C, XLT5026,

ZQL9712, ZQL9712HV, etc.

Auxiliary software is “LED Control Software”. When set the modeling

for H801SC, must select “one line shares a slave controller”, when set the

Summary of content (4 pages)

PAGE 1
H80ⅹSC INSTRUCTIONS 1. Introduction H80xSC includes H801SC and H802SC, they are synchronized with AC power supply. H801SC has one output port, only PORT1 or DMX_OUT1 can be used, controls maximum 1024 pixels; H802SC has two output ports, each port can control 1024 pixels, when controls P9813 and LPD6813, each port can control maximum 768 pixels.
PAGE 2
modeling for H802SC, must select “two line share a slave controller”. 2. Performance 1. H801SC has one output port, controls maximum 1024 pixels; H802SC has two output ports, controls maximum 2048 pixels. 2. Use the dial switch to set the play speed, clock frequency; the SD card can be replaced with power-on. 3. SD card supports FAT32 and FAT16 format, the maximum capacity is 64G bytes, stores maximum 64 DAT files. 4. The type of driver chip and scanning frequency are set in “LED Control Software”. 5.
PAGE 3
H801SC, flashes twice is H802SC，after that, the indicator will light normally. The indicator light will flashes every one second if there are too many pixels or the DAT file is incorrect. 5. I f you want to change the SD card with power-on, please turn the fourth, fifth dial switch on, the indicator light will flash per two seconds at the same time. Turn the fourth, fifth dial switch off, the controller will continue working. 6. Set passwords.
PAGE 4
2. Switch 5 is used to replace the SD card with power-on, dial it to “ON”. Dial switch 4 and switch 5 to “ON”, the controller is not working, you can replace the SD card right now, dial switch 4 and switch 5 to “OFF”, the controller will continue working. 3. Switch 6 and switch 8 are used to set the playing speed, the unit is frame per second. The speed will be effective after power-on or inserting the SD card. Dial Switch Speed 1 2 5 10 12 17 25 50 5.