User Manual

power supply
7、 Trouble shooting
Question 1：After power, the T-1000S ERROR indicator has been flashing without display output
answer：The ERROR indicator flashing means the controller did not read the card correctly,
possible problems:
② SD card is empty, with no effect file.
②The effect file in the SD card and the controller model do not match, please choose correct
controller model in LedEdit and then re-create the effect file *led.
③SD card is not formatted to FAT before copying effect files.
④Please check the supply power voltage, the controller can be individually powered to
exclude power reasons
⑤Change the SD card and then test to exclude the possibility of a bad SD card
Question 2: The controller is powered on, the indicator is normal, but no effect change in
lighting
Answer: The reasons for this are as follows:
① Check if the lighting′s signal line and the controller are connected correctly
② If the TTL signal is received, the lamp and the controller must be common ground, that
means connect the lighting′s and the controller′s ground together
③ Check if the model chosen during creating display files on the SD card match the chips
used in the lighting